Re: [Boost-testing] ICU on KTC-Win7x64_VC10x64

Subject: Re: [Boost-testing] ICU on KTC-Win7x64_VC10x64
From: Artyom Beilis (artyomtnk_at_[hidden])
Date: 2011-07-17 08:44:52

----- Original Message ----
> From: KTC <ktc_at_[hidden]>
> To: boost-testing_at_[hidden]
> Sent: Sun, July 17, 2011 3:30:11 PM
> Subject: Re: [Boost-testing] ICU on KTC-Win7x64_VC10x64
> 
> On 17/07/2011 09:48, Artyom Beilis wrote:
> > Hello,
> > 
> >>  From the description of KTC-Win7x64_VC10x64 it seems that ICU 4.8 should
> >  be installed there but it seems to be undetected. One reason it
> > may  happen that the provided libraries are build in release
> > mode and debug  libraries are required.
> > 
> > - Is it possible to get the contents  of
> > 
> >     $(ICU_PATH)/bin
> >      $(ICU_PATH)/lib
> > 
> >     For this system?
> > 
> >  - If there is no debug version of icu libraries (icuucd, icuind) is it  
>possible
> >    to install them?
> 
> The fault in this case is  in Locale configuration, not my end where ICU (debug 
>& release, x86 &  x64) was build from source.
> 
> Since ICU4C 4.6, x86 outputs has gone into  /bin & /lib, whereas x64 outputs 
>has gone into /bin64 &  /lib64.
> 
> The problem is evident from me running the regression test for  x86:
>   (Regex config test)  - has_icu builds            : yes
>   (Locale config test) - icu                       : yes
> Running the  regression test for x64:
>   (Regex config test)  - has_icu  builds           : yes
>   (Locale config test) -  icu                       : no
> 
> KTC-Win7x64_VC10x64 runs with '--bjam-options="architecture=x86"  
>--bjam-options="address-model=64"'. KTC-Win7x64_VC10x86 is the x86 targets  
>runs.
> 
> Regards,
> 
> KTC

Thanks!

I'm going to fight BBv2 once again [sad-very-very-very-sad-face]

Artyom