Boost Users :
Subject: [Boost-users] [test] CLOSE and CLOSE_FRACTION tolerance
From: Edward Diener (eldiener_at_[hidden])
Date: 2011-06-02 21:19:50
I am trying to understand the tolerance value passed as the last
parameter to the BOOST_XXX_CLOSE and BOOST_XXX_CLOSE_FRACTION macros.
The doc says that for the former the value is percentage units while for
the latter it is the fraction of absolute values being compared. But in
each case there are two values, not just one. Which of the two values
are used to determine the tolerance amount in each case ? If both values
are being used in each case, how is the tolerance amount computed from
the tolerance value passed ?
Boost-users list run by williamkempf at hotmail.com, kalb at libertysoft.com, bjorn.karlsson at readsoft.com, gregod at cs.rpi.edu, wekempf at cox.net