Boost logo

Boost Users :

From: bringiton bringiton (kneeride_at_[hidden])
Date: 2007-05-22 01:29:39


Thanks for tip aaron.

I'm planning on using a message length byte at the start of the
packet. Therefore the reader reads the byte and then waits until there
are X bytes in the stream before it reads.

I asssume you are talking about << and >> operators for parsing. My
concern here is that if the message has not been completely sent, then
the reader will be blocked. I'm using TCP asynchronously.

On 5/22/07, Aaron W. LaFramboise <aaronrabiddog51_at_[hidden]> wrote:
> bringiton bringiton wrote:
>
> > Are there any solutions to this? ie building messages as they come in
> > through the TCP stream.
>
> Parse data from a socket stream the same way you'd parse data from any
> other sort of stream, such as a file. That is, design the protocol such
> that end-points can parse the message using its own contents, rather
> than meta-data such as 'messages.'
>
> Possibilities:
> 1) Use delimiters.
> A. Use text and use CRLF for a delimiter.
> B. Use a special octet as a delimiter, such as the null character.
> 2) Use message content-length
> _______________________________________________
> Boost-users mailing list
> Boost-users_at_[hidden]
> http://lists.boost.org/mailman/listinfo.cgi/boost-users
>


Boost-users list run by williamkempf at hotmail.com, kalb at libertysoft.com, bjorn.karlsson at readsoft.com, gregod at cs.rpi.edu, wekempf at cox.net